Lumenier 4Power + Plus PDB er ett strømforsyningsbrett for FPV-racere.
Product details in english
Details
The Lumenier 4Power + Plus PDB is a feature rich power distribution board designed for small quadcopters. The board uses the standard 30.5mm mounting hole pattern (common to most flight controllers) to easily fit up to most airframes. This PDB features an easy to solder layout keeping builds clean and simple. The 4Power + Plus has all your power needs in one place with an onboard 5v and 10v BEC as well as a 184A capable Current Sensor. It can support from 3-6s LiPo battery and includes a lay-flat XT60 plug for low profile builds. Alternatively, you can simply solder power wires directly to the PDB and use a cable tie to secure it in place, reducing stress on the solder point. Each voltage regulator can supply up to 2A of current, allowing them to easily power your VTX, camera, FC, and some LEDs.
Features
Input voltage range (3S-6S operation): 8 - 26VDC
PDB: 4x30A (Max.4x46A)
Regulated 5V (1.5A) and 10V (1.5A) outputs
Current Sensor 184A
Specifications
2oz copper, 4-layers &1.6mm PCB.
1x Battery input, 4x ESC outputs. 2x BEC 5V outputs, 2x BEC 10V outputs.
Current Sensor, Gnd pads, Video Transmitter Signal & Gnd pads
Dimensions: 46x36x4mm, Weight: 8.5g
Mounting holes 30.5mm square spacing,?3mm
PDB (ESC outputs)
Continuous current: 30A per output Peak current (10 seconds/minute): 46A Max per output
BEC 5V outputs
Designed for RC Receivers, Flight controllers, OSD, and Servos.
DC/DC synchronous buck regulator.
Voltage: 5.0 +/- 0.1VDC
Continuous current: 1.5 Amps (Max.2A 10s/minute)
Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)
Short-circuit tolerant (5 seconds/minute)
BEC 10V outputs
Linear regulator, very low noise. LC Filter is needless.
Designed for Video TX or FPV camera.
Stable power output even on low voltage 3s (below 12v)
Voltage: 10.0V +/- 0.3VDC (4~5S operation)
Continuous current: 1.5A@16V IN (2A Max)
Short-circuit tolerant (2 seconds/minute)
Current Sensor
184A / 3300mV
Includes
1x Lumenier 4Power + Plus PDB
1x Lay-Flat XT60 power connector
1x Set of Nylon standoffs
4x M3 6mm hex standoff
4x M3x12mm screws
4x M3 hex nuts
Mer info på Engelsk