Print produktark

Airbot Typhoon 4in1 ESC PRO 4x20A 3-6S

Ikke lenger lagerført
Årsak kan være at produktet er utgått fra leverandør, erstattet med ny vare, eller har hatt for liten etterspørsel. Eventuelle spørsmål kan rettes til kundeservice.
Produktinfo
Tips en venn
Anmeldelser

Produktinformasjon

Airbot Typhoon 4in1 ESC PRO 4x20A 3-6S
3-6A 4i1 fartsregulator for FPV-racers. Regulatoren yter 20A pr utgang og kjører BLHeli firmware. 35x35mm.
Typhon 4x20A PRO har F396 MCU og kjører BLHeli LittleBee Pro20A firmware. Regulatoren er 35x35mm og monteringshullene er 30x30mm. Ingen bec.
Product details in english
f you?re looking for amazing performance in a tiny package, checkout the Typhoon 4-in-1 Pro ESC which is a single PCB containing four 20amp LittleBee ESCs in a 10 gram package.

The same size as a standard 35x35mm flight controller and with 30.5x30.5mm mounting holes, it will stack neatly along with your flight controller and PDB. It has easy-to-solder, gold plated solder points for the motor and power leads. The ESC signal input plug is a 6pin SH1.0 connector for easy connection to most low profile boards. Alternatively, use the included SH1.0 to 2.54mm DuPont breakout cable to connect to your standard servo pin headers.

Some high performance ESCs are known to have problems that can cause voltage spikes, especially when damped light is enabled. On these ESCs the problem can be mitigated by adding a large external capacitor. However with theTyphoon 4-in-1 Pro, this issue has been taken into account in the design and extensive testing has been done to ensure that no external capacitor is needed, even with damped light enabled.

It comes with both the BlHeli firmware and the BlHeli bootloader installed for easy CleanFlight and BetaFlight passthrough programming. When updating to a new version of BlHeli, use the LittieBee Pro 20A firmware.

Damped Light will make huge voltage spikes on LIPO side, please make sure your device works with that.

Features:
F396 MCU, 48Mhz Runs BLHELI LittieBee Pro 20A firmware 3-6S
4PWM input, works with our FLIPAIO/PX4AIO and all other FC
Supports oneshot PWM
Only 35x35mm, mount holes 30x30mm (on new batch, the holes will bechanged to 30.5x30.5mm)
Supports damped light
no BEC output
NO External capacitors needed
80A(4x20A) peak(under air flow), 60A(4x15A) peak(in frame)
60A(4x15A) continued(under air flow), 40A(4x10A) continued(in frame)
Different frame will cause different test result with the current, we rated it as the mid-value, in your frame, the current may higher or lower, there is no Guarantee, if you can get same result in your frame.

Package incl.:
Typhoon 4x20A 4in1 ESC
6pin SH1.0 to 2.54 DuPont Cable
Mer info på Engelsk
Flere så også på